How to Build a Craps Table Part 9

Posted December 6, 2012

I needed to make the dealer chip tray holder match the rest of the table. I used some of the 1/4 inch plywood I had left over and added it to the top of the existing board.  I attached it with two countersunk screws, and cut out the hole for the blackjack chip tray.

Then I stained and Polyurethene’d it. I cut a couple of 2×4 pieces to hold it up off the table. Those got stained as well.

You can see some  of my chips are from thechiproom.com . I ordered some more, cuz I like ’em.

I’m thinking of cutting a hole in the empty area of the board to put the round dice boat in.

Posted on December 6th, 2012 by Clayton

Posted in Craps, Woodworking

Comment on this post

Leave a Reply